Paul,  here is the Barry mount bracket.  It cost   $275.00 plus
materials and 4 hours labor.  That is what my wife says.  Actually I
wanted to buy the rotary table anyway and this little project
provided an excuse.  Four hours labor to learn the rudimentary use of
the table.  I could find very little  help, so I proceeded by the
screw-up method, a very effective learning technique that I have
mastered, until I got to the point I am at now, able to cut the
outside radius.          Jerry


Try a band saw and a disk sander. Don't tell your wife :)

-
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.