Subject: Make your own e-shaft
From: Rotary Engine
Date: 2/5/2007, 5:31 PM
To: AARotary Engine


>> Gentlemen,
>> I agree I did not follow exactly what you are
trying
>> to do.
>> Sorry if I said something silly.
>>
>> All I was saying is that 500 ftlbs of torque
require
>> a larger than 1"
>> solid shaft,
>> even if made out of higher grade shafting
material.
>> The G-Modula, or
>> springiness
>> of the various steels does not change with their
>> ultimate strength,
>> although their load capacity does.
>> But often vibrations lead to breaks, not the
torque
>> load.
>>
>> If the torque is not smooth then an additional
load
>> factor must be used,
>> depending
>> on the torque fluctuations of the source. With a
six
>> rotor unit the
>> fluctuations are not
>> as high as from a two rotor. But still, 20 or 30
%
>> should be added to
>> the torque.
>>
>> Rolf
>
> Kenneth
> I checked with an ME friend about your comment
that
> the journals and lobes would add strength to the
> splined shaft. He said they would contribute
little
> and the majority of the torque introduced into the
> shaft by the lobes would be carried by the shaft.
With
> the stress formula provided by Rolf and your 1.182
> dia, the safe max torque would be 213#'. Is this
about
> right, Rolf?
> regards, Robert
>
Robert,

Yes your number is correct. (I get 216 ftlbs using
PI/16 instead of 0.196.)

If the shaft is splined with a DP 24, the depth I
find is .098 ".
Subtracting that from 1.182 we get 1.0836" as root
diameter.
The maximum torque is then near 167 ftlbs.

Applying a factor of say 1.25, the torque applied
should only be near
133 ftlbs.

Regards, Rolf


I am reposting my last msg from a couple days ago; it
seems to have been lost.


Rolf, Bill and Kenneth
Thought I would give one more try on this subject. If
it is possible to operate lobes and journals with a
thin wall of .06" min, then the min dia of the spline
approaches 1.47" [1.69-2(.06)-.098] which meets Rolfs
stress criteria at 415#', without the torque ripple
factor. My question is simple; is this wall too thin?


Kenneth
Have you addressed the rather large tapped holes
required for the oil squirt jets? Seems they would
take away a lot of the shaft cross section area.

regards, Robert




The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.