Robert,
My comments were meant to raise awareness and
concerns.
By all means, build it and see what happens.
Technically, you are talking many different things
here.
Looking at shear, the load of the piston at maximum
gas pressure is near
27,000 to 32,000 lbs.
245.5 cm^2 * 50 to 60 bar = 12275 to 14700 kg *
2.205 = 27,060 to 32,480
lbs total.
At a high charging rate it is even more.
In the case of the e-shaft, we have combined
stresses of shear, bending
and torque.
As a good approximation, two forces are added
quadratically, meaning
sqrt ( A^2 + B^2)
Or in this case sqrt ( A^2 + B^2 + C^2 ). But that
is not necessarily
correct.
To be precise an analysis of the time and angle of
these three forces
must be made. Not that easy.
Regarding storing energy through wind up, yes that
is occurring.
Heat will be introduced and most importantly, the
stiffness or rather
self frequency of the shaft must be known
together with the input cycle of the forces. But
this applies to longer
shafts only.
Axle shafts just carry torque, no bending and no
shear. Different
situation to an e-shaft.
The e-shaft when weakened as proposed, should also
be checked for its
own frequency.
Being much weaker, more deflection is being
introduced which is a key
enemy of the Wankel engine.
Any vibration may lead to the so called chatter
marks. That may be
encountered with a weak shaft.
Enough said, try it anyway.
Regards
Rolf
PS. For 2000 inlbs of torque I get 377 psi for the
example you send. He
calculates 296 psi.
The low number is unrealistic for steel or practical
engineering. The
shaft may be wood or plastic.
The length is irrelevant if no material and its
G-module is given.
Gentlemen
I was skeptical of the shaft strength from the
beginning. You have pointed out in detail the
weaknesses and as I said: last try. I have no further
interest in it.
regards, Robert
Robert,
Sorry, I made a mistake in the above calculation, as the
piston [rotor] area is 145.5 cm^2 instead of 245.5 cm^2.
(Just wasn't careful and going by memory).
That means maximum piston force at low speed is near 16,000 lbs
to 19,000 lbs.
Still, its a lot.
Rolf
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.