Subject: Superchargers and Efficiency
From: Rotary Engine
Date: 2/9/2007, 3:32 PM
To: AARotary Engine



   ...snip,


   Paul,

   While on the supercharger subject: a fellow on a Yahoo list is
   experimenting with a 1/2 turbocharger. He removed the broken exhaust
   side, and added a cog belt drive -stepup 1:10 ratio- in it`s place. He
   only wants 2-5 psi, so the compressor speed is adequate.

   A really cheap supercharger.

   Do you think such a concept will be (remotely) efficient and workable?

   -
   Erik Snyman
   Messina
   South Africa.

   You pay a fuel penalty with all super chargers as opposed
   to turbo chargers. All the HP to drive the supercharger
   comes from the net mechanical HP of the engine. In other words
   if your super charged engine is generating 200 HP net at the
   e-shaft the engine is burning 220 HP worth of fuel.
   The BSFC does not change. At a BSFC of .5 the fuel burn
   is 110 pounds an hour or 18.33 GPH.

   If your turbo charged engine is making the same net 200 HP
   at the shaft the engine is burning only 205 HP worth of
   fuel or 102.5 pounds or 17.08 GPH. The supercharger is
   costing you over 1.3 GPH in this case. The reason is the
   turbo charger is extracting otherwise waste
   HP from the exhaust. A step towards turbo compounding.
   It gets even better at altitude for the turbo charger.

   Note the efficiency of just the compressor is the same
   in both cases because he is using the same compressor.
   Centrifugal compressor efficiencies are the highest in
   the compressor industry. Also the mechanical drive for the
   super charger is not 100% efficient. If the compressor is 80%
   efficient and the drive 98% efficient the overall super charger
   is only .98 times .8 or 78.4 % efficient.

   Paul Lamar ...No rotor no motor.

   Paul,

   A turbocharged engine is more fuel efficient than a supercharged
   engine, as you said.

   However, that's not the whole story for airplane efficiency. A
   supercharged airplane can be more fuel efficient than a normally
   aspirated plane -- although not quite as efficient as a turbo plane.

   The reason is that a supercharged engine can let us to fly at higher
   altitudes where dynamic pressure is lower, so we can fly faster at
   lower power level. This results in more range for the amount of fuel
   burned, or better miles per gallon.

   Let's take a Cessna 182 for example, which has a 230 hp engine and
   cruises at about 145 knots at 8000 feet at 75 percent engine power.

   Dynamic pressure at that speed and altitude is 55 pounds per square
   foot. The 182 has an equivalent flat plate area of about 5.5 sq-ft,
   so total drag is 302.5 lbs.

   With a supercharged engine we can cruise easily at 16,000 where
   dynamic pressure is only 42 psf at the same 145 knots. Our total
   drag is only 231 pounds. We can reduce power to about 55 percent to
   fly the same speed.

   Even though it is costing us a little bit of power to run the
   supercharger, the reduced power setting more than makes up for it.

   We can run through the numbers quickly to see just how much:

   At 8000 ft, our drag is 302.5 lbs. Since thrust must equal drag in
   straight and level unaccelerated flight, our engine and prop must be
   making 302.5 pounds of thrust.

   Thrust is simply power available divided by velocity. So we can
   calculate power available by multiplying our thrust times our velocity:

   Power available = 302.5 * 245 fps / 550 = 135 thrust horsepower

   (We divided by a constant of 550 because one hp equals 550 lbs. * 1
   ft.; or 1lb * 550 ft).

   The actual engine horsepower is just thrust horsepower divided by
   our propeller efficiency so if we assume prop efficiency of 0.8 we
   get 135 THP / 0.8 = 168. This is 73 percent of the 230 hp engine's
   power. Assuming a fuel burn of 0.45 pounds per horsepower hour, we
   find that we are burning 75.6 pounds per hour, or 12.6 gallons per hour.


   Now flying at 16,000 feet with our supercharged engine, we have a
   drag of only 231 pounds.

   This requires only 102 THP. ( 231 * 245 fps / 550 = 102)

   102 THP divided by our prop efficiency of 0.8 equals 128 engine
   horsepower. This is 55 percent power. Assuming a higher fuel burn of
   0.5 pounds per horsepower hour for our supercharged engine, we get a
   total fuel burn of 64 pounds per hour or 10.7 gph.

   We are flying the same speed, 145 knots in both cases but our
   supercharged engine flying at 16,000 feet is burning nearly two
   gallons less fuel per hour. over a four hour trip we can increase
   our endurance by three quarters of an hour and increase our range by
   more than 100 nautical miles.

   A turbocharged engine would be even more efficient, but a
   supercharged engine is still better than NA. The supercharged WW2
   fighters got pretty good range and endurance by cruising up high at
   low power levels and could circle for quite a while like this until
   they spotted bogies. Only when they engaged did they go to high
   power and this usually did not last more than a few minutes.

   Supercharged engines have the advantage of easier boost boost and
   you don't have the heat issues of a turbo.


   Regards,

   Gordon.

   All very true. No doubt about it.
   You need oxygen at 16,000 feet and IFR in most places in the US :)
   I don't know about Canada. I think 12,000 feet is a more practical
   altitude limit for most of us VFR pilots in the US.

   BTW As I recall VFR on top is illegal in Canada as I recall. Every
   time I fly in Canada there always appears to be a top :)

   Paul Lamar

   Right you are Paul,

   Here in Canada we have a so-called VFR-on-top rating, which lets a
   VFR pilot get on top. In the US you can do that with just a VFR rating.

   I think the US requirement is that you have to file an IFR flight
   plan for 18,000 feet and above.

   Regards,

   Gordon.




The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.