> Here are some shots of Tracy 20B 3 rotor engine in his RV8.
> Close to flying. He is waiting for his Blue Mountain glass
> cockpit. The roughly 12 inches long intake tubes are in the
> large wooden plenum. The throttle body is an RX8 fly by wire!
> IMHO scary :) He is using RX8 coils. He said the hot tip
> for the GM V8 coils is the truck versions. I don't have a part
> number yet. Those are the ones that have heat sinks.
>
> Paul Lamar ...No rotor no motor.
Hi Tracy,
where did you get the connectors for the RX8 coils? I recently got a
set of
coils for the single rotor from Metromotorparts, a real bargain at
$27.00 a
piece. Also got the crans angle sensor, the same problem.
The single rotor is going on the test stand for running the compound
side
housing.
Thanks.
Richard Sohn
8029 HWY 1087
DeFuniak Springs, FL 32433
Connectors are a big problem on this stuff. I frequently end up
soldering wires to the terminals and potting the connector well with
epoxy. Never had a problem with this method. The pictured RV-8
connectors came from the Renesis crate engines I bought some time
ago for R&D purposes ( just started after a 2 year delay).
Tracy (back from brother's divorce court hell)
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.