Paul,
Thanks for the info on Microchip.
In the six weeks I was away did you find a way to use the constant spray
slide throttle system with a turbo charged engine? I checked out your
latest drawings on the website. Correct me if I am wrong but it appears the
latest configurations is quite an improvement over the gravity flow system
and if I am not mistaken it is a low pressure electronic fuel flow
controller.
You probably had lots of discussions about this design but something Matt
just commented on makes me wonder why the need of a pressure regulator. A
small pressure tank with an internal diaphragm to dampen out the pulses I
can understand.
Let me see if I got this right.
If the throttle is opened, more holes are uncovered and fuel pressure must
drop. The fuel pressure sensor then responds by having the duty cycle of the
pump increased to maintain the required flow pressure. Since we can only
push so much fuel through a little hole and pressure will increase faster
than flow, fuel flow is tied to throttle setting and how many holes
(injectors) are open at the time.
If that is the case then changing the duty cycle by tweaking the fuel
pressure control would act as a leaning mechanism right?
It seems we are trying to control flow where controlling pressure through
what are basically will be a series of optimum shaped injectors might
accomplish the same aim?
Doug Fir
On the constant dribble, super simple, all mechanical system
Doug suggested using the knob on the pressure regulator
to lean the engine. That in theory allows doing away with the leaning
needle valves. Here is a 3D on that system.
The pressure would have to be increased and the holes made
smaller so one would get a wider ranges of fuel flows.
Good idea Doug. I am not sure you would get a wide enough range
but a bench test should prove that one way or another.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.