Hi,


Some questions:

Any advantage to using an under drive pulley in an aircraft
installation?  Would it help with the higher constant RPM's I will be
running?

I have to move my alternator on my Renesis engine to the side, rather
than have it on top as it comes, when I do so I will have an
interference problem with the pulley belt and the crank angle sensor.
Can I use washers or a plate to move all the pulleys out to eliminate
the problem? Would there be any concerns doing this?

Does anyone know of a good oil filter relocation kit for the Renesis
engine?


Thanks,
K11

Paul Kvernplassen
Building a GlaStar in Alaska

Might in your case as it is cold up there :)
I am not so sure it is a good idea down south where the climate
is hotter and cooling is more critical.
Not on my list of priorities.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.