Subject: Aluminum center/end plate ?
From: Rotary Engine
Date: 2/21/2007, 4:51 PM
To: AARotary Engine


Paul: You, any one else, ever look at RB's aluminum end and center
housings
and wonder how much trouble to machine out of solid aluminum billets for
PPort engines? After all, they won't need intake ports in them.
jofarr, soddy tn

Can't be done because they are hollow. Now if somebody invented
a tiny robot milling machine that you could put down a small hole
and have it mine out cavities in the material that would work.

No intake ports would certainly help.

If you made them in two pieces that would also work if you could
figure out a way to seal the internal joints. Could be done with
some sort of gasket or O-rings and that is exactly what Richard
Sohn is working on.

Paul Lamar ...No rotor no motor.

Paul,
Those two pieces could easily be furnace brazed together. According to
Alan Tolle Everett even did a steel 2 piece milled and furnace brazed.
For the "superlite" engine. For aluminum the problem remains the coating.
I'm convinced that it would be "do able" just expensive. I think that the
state of milling equipment probably do a better and faster job than
casting.
Bill Jepson

hi  Bill,  this is the way my machinist and i have planned to do it. what
would you estimate the cost of casting them? just so i could compare
costs.
thanks ,  wyo. walt.


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.