> Paul: You, any one else, ever look at RB's aluminum end and center
housings
> and wonder how much trouble to machine out of solid aluminum billets
for
> PPort engines? After all, they won't need intake ports in them.
> jofarr, soddy tn
>
> Can't be done because they are hollow. Now if somebody invented
> a tiny robot milling machine that you could put down a small hole
> and have it mine out cavities in the material that would work.
>
> No intake ports would certainly help.
>
> If you made them in two pieces that would also work if you could
> figure out a way to seal the internal joints. Could be done with
> some sort of gasket or O-rings and that is exactly what Richard
> Sohn is working on.
>
> Paul Lamar ...No rotor no motor.
>
> Paul,
> Those two pieces could easily be furnace brazed together. According to
> Alan Tolle Everett even did a steel 2 piece milled and furnace brazed.
> For the "superlite" engine. For aluminum the problem remains the
coating.
> I'm convinced that it would be "do able" just expensive. I think that
the
> state of milling equipment probably do a better and faster job than
> casting.
> Bill Jepson
> hi Bill, this is the way my machinist and i have planned to do it.
what
> would you estimate the cost of casting them? just so i could compare
costs.
>thanks , wyo. walt.
Walt
The problem is the cost of the pattern making. You could easily spend 10K
to 15K setting up the patterns to cast the various parts. That is before
making a single casting. Additionally the sad thing is you could find
that your
casting still didn't work due to porosity or core shift. The fact is
that billet
construction would probably be cheaper until at least the 100 unit mark.
machining from billet you have a reasonable expectation that your first
part
would work. All the aluminum concerns about coating are about the same.
Bill Jepson
One possible problem I can see Bill is the compressive strength
of furnace braze is not as high as the base material.
The tension bolts put a lot of compressive stress on
the engine end housings.
Paul Lamar
hi all, forget the tooling [cost?], and i am sure we will be way
beyond the 100 mark soon . what will the foundry charge us
to cast them in quantity? thanks
wyo. walt The
Around $4 to $5 a pound.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.