Do the two bottom outboard bolts have to be RTV coated like the 16 other
tension bolts?

Would it hurt to leave the outer race of the needle bearing  in the end
of the E shaft in place.?

I ground the front half down even with the
shaft hole but have been unable to pry it out.
I found I could tap the Renesis fuel injector holes in the intake
manifold with a 1.5mmx12 tap without further drilling. Those will be for
the dribble nozzles I still have to make.
I also found I will have to notch my six port slide thottle to clear the
water pump housing. Will take a picture when it is done.
I still have no idea on how big a hole my six dribble nozzles will need.
Trail and error, I guess.  Karibian

Just where they go through the center housing.

No if Tracy' shaft fits in there with no slop.
If not you need to get it out and fit a bushing in there.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.