Subject: Aluminum center/end plate ?
From: Rotary Engine
Date: 2/23/2007, 10:03 AM
To: AARotary Engine




    > Fair enough..  None the less, using iron wear surfaces gets
   around some
    > surface finish issues, and might make machining a billet part
    > simpler/easier/cheaper.
    >
    > However you look at it, it's probably still cheaper to order the
    > housings from Racing Beat and be done with it.
    >
    > Matt-

   Matt,
   That's about the full extent of it - sad as it seems.
   George ( down under)

   My guess is 50 pounds saved for $4500 is too much money
   and not worth it for the vast majority of 2 rotor users.

   The one rotor is another matter as the 30 pounds saved
   is a more significant part of the total weight. However
   a one rotor Mazda is more expensive than a two rotor Mazda.
   One would be adding $3000 to the cost of that for
   RB aluminum housings.

   There is nothing intrinsically
   expensive about the way Richard Sohn is doing it.
   You mostly have casting cost of about $5 a pound ($150 for
   an end housing) and any machine shop can finish them
   without the cost of an  NC mill. Also there is far less
   technical risk as it uses low tech proven technology.
   --
   Paul Lamar ...No rotor no motor.

Paul,

When somebody forgets to sign their post, please just sign it for
them..


Hah.


Hah who? :) I usually do. OK this remark came
from Matt :)

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.