I suspect rear PSRU seal problems are caused by Tracy's input shaft not
being concentric with the e-shaft. That means the needle pilot bearing
in the aft end of the e-shaft has not been properly removed or the
input shaft diameter does not fit the hole perfectly.
One needs to check the run out with a dial indicator.
--
-----------------------------------------------
In Ian's case perhaps his after market bell housings was incorrectly
machined. It is not easy to line up the hole in a bell housing
with the e-shaft axis. A special tool must be made that fits
into a partially assembled engine without e-shaft or rotors. This
tool is a round shaft that just fits the main bearing bores with
a small tapered tip that can be used as a marker punch on the inner
surface of the bell housing bolted to the rear end housing.
Basically what you are doing is align boring the bell housing.
Also attention must be paid to just the right amount of oil
getting to the PSRU and adequate diameter drain back hoses going
to a four inch deep or deeper oil pan. The stock RX8 oil
pan is not adequate in any sense of the word.
Turbo chargers have the same problems.
Paul Lamar
Hello,
This brings up a question that I have always had with my Ross PSRU. The
previous owner of my project removed the pilot bearing from the e-shaft.
Was the pilot bearing supposed to be removed? I would have thought it
should stay to keep the PSRU input shaft centered on the e-shaft.
Cheers,
Burck Hantel
The Ross uses a spring clutch disk bolted solidly to the flex
plate. If that was not done correctly the input shaft
will not be concentric and will not fit the pilot bearing.
Check the run out on the clutch disk.
--
Paul Lamar ...No rotor no motor.
I had a run out problem on my Ross gearbox do to poor machining by
that crack head so what I did was to mount and zero in a end housing
on my mill and then I bolted on the bell housing to the end plate and
then re boring and bushing it, no not kidding about Chris being a
crack head as I talked to someone that was looking for him with a
rope in hand and the neighbor said that he was not home because he
was in drug rehab.
Ken
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.