Subject: Carb air intakes
From: Rotary Engine
Date: 2/28/2007, 6:08 AM
To: AARotary Engine



Every once in a while the subject comes up about
air intakes and how close to the prop they should be.
 Here is an old 1942 NACA paper on the subject.

This is the site where you down load it.

http://ntrs.nasa.gov/search.jsp?N=17&Ne=2

These old NACA reports are a gold mine on the info we need.

-- 
Paul Lamar ...No rotor no motor.

Nice paper.

I would have been nice if the author's had provided units for the parameters
shown on pp. 2-3. Most seem intuitive.
However, one of the important parameters is undefined, at least in terms of
units: Q, the air-flow quantity. What are the units for Q? Pounds, cu. ft.
or what? From the figures Q/Vo seems to have a low value, considerably less
than 0.1.

My guess is that Q is cu. ft. of air per second consumed by the engine. Then
the expression Q/Vo has the units sq. ft. Which would correlate nicely with
the inlet area of the scoop. A Q/Vo of 0.05 is 28 sq. in., which agrees well
with one of the tested scoops.

What I conclude from reading this paper is that the scoop should be round,
tangent to the skin of the cowl, and have a negative angle of attack in
order to obtain a Vi/Vo of 0.3 to 0.5. It would also seem that Q/Vo should
be around 0.05.

Also very important is the duct leading to the induction (carb) device. A
bad bend (small radius) can result in poor performance.

It is a shame that many of the graphs are unreadable or very difficult to
read.

Doc Custer
Retired Software Engineer and sometime Audiologist

That really makes me mad that they did not scan this old
stuff at much higher resolution. The photos are near useless.
It was probably on microfiche and the scanning was done
at low rez.

There is also a dwg and coordinates for prop cuffs in this paper.
It sure looks like Tracy Crook read this NACA paper when he added
prop cuffs and a carb air intake for his RV4 :)
Do you have this NACA paper Tracy?

Tracy said something like the cuffs and the scoop were worth
about 3 MPH on the top end. I am not sure I got all that straight
or if I am quoting him correctly.

All you guys with Warp Drive and IVO props on your airplanes
would benefit greatly from prop cuffs.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.