Here's a question; on Paul's site, under Low Cost Fuel Injection,
there's a link to the 300 horsepower 1980's engine. What would
it take to just get that engine and use it? I know you'd take
off pollution stuff, but wouldn't that basic setup work? If so,
was it actually used in that configuration, in a production car
that one could get at a junkyard?
I know I'll be asking stupid questions for a while and I
appreciate everyone's patience.
Terrance Langen
That is at 8500 to 9000 RPM. We are limited by our gearboxes
and props to 7500 RPM. So only about 240 to 250 HP is available.
That is an old p-port 13b racing engine from the 1980's and has
a slide throttle and mechanical fuel injection. No pollution
stuff. Pretty much what Mazda patterned their 1991 Lemans
winning four rotor engine on and I copied when we built the p-port.
No new technology here. The runners need to be a bit longer
for 7500 RPM. You can do that with just about any 13B or RX8 engine.
Piece of cake.
--
Paul Lamar ...No rotor no motor.
Looks like an attractive course to take, to me. I like simple and
I'd rather be flying than inventing. Can't stand the 1930'
Lycoming and Continental lawnmower engines.
Terrance Langen
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.