Just to let everyone know I had a serious problem
with a landing
today and the plane is seriously damaged. Pilot has
a scratch on his
thumb.
I had a pretty bad bounce on landing and after the
second bounce,
decided to go around. That was a mistake. I never
got out from behind
the power curve and ended up doing a high power skid
into the grass on
the south side of the runway. Both main wheels were
torn off, the prop
disintegrated, an the fuselage is somewhat bent.
After contacting the
ground, the plane did about 1/2 turn and skidded to
a stop.
Bob W.
--
N93BD - Rotary Powered BD-4 -
http://www.bob-white.com
First Flight: 11/23/2006 7:50AM - 3.3 Hours Total
Time
Cables for your rotary installation -
http://www.roblinphoto.com/shop/
Dang! I was just about to go over there and take
some pictures
of Bob's airplane. I have never been a fan of tail
dragger's.
I think they add to the hazards of aviation. They
are fundamentally
unstable on the ground. The CG is behind the main
wheels. Therefore
there are situation where they are impossible to
control no matter
how good the pilot.
--
Paul Lamar ...No rotor no motor.
A tail dragger is flown until it is in the chocks.
Karibian
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.