Subject: Aluminum center/end plate ?
From: Rotary Engine
Date: 3/7/2007, 10:48 PM
To: AARotary Engine




    >      > Paul: You, any one else, ever look at RB's aluminum end
   and center
    >      > housings
    >      > and wonder how much trouble to machine out of solid aluminum
    >     billets for
    >      > PPort engines? After all, they won't need intake ports in
   them.
    >      > jofarr, soddy tn
    >      >
    >      >
    >      > Can't be done because they are hollow. Now if somebody
   invented
    >      > a tiny robot milling machine that you could put down a
   small hole
    >      > and have it mine out cavities in the material that would
   work.
    >      >
    >      > No intake ports would certainly help.
    >      >
    >      > If you made them in two pieces that would also work if you
   could
    >      > figure out a way to seal the internal joints. Could be
   done with
    >      > some sort of gasket or O-rings and that is exactly what
   Richard
    >      > Sohn is working on.
    >      >
    >      > Paul Lamar ...No rotor no motor.
    >
    >     Well, maybe great minds do run along similar tracks; but,
   then again,
    > I
    >     can't help but wonder why it occurred to me also<g> The idea
   of doing
    > two
    >     sides and sealing together or just drilling, milling and
   making oil
    > and
    >     coolant paths where necessary, plugging where necessary as
   well and
    >     going
    >     from there; or, even doing thin steel sheets to fit over aluminum
    > center
    >     section or even furnace braze all stamped steel for each housing
    >     just seems
    >     well worth while for those more talented than I.
    >
    >     jofarr, soddy tn
    >
    >
    > The hollow section is done using plaster like material mold with
   latex
    > or rubber mold. Then the Cast Iron is poured. What you can do is
   cut a
    > housing in half, and use it as a female mold. Then the plaster
   mold is
    > molded inside the aluminum housing. Then water can be used to
   dissolve
    > the plaster like material (paraplast). This should be heated to
   600F and
    > then poured in the mold.
    >
    > Roderick
    > Was in Malta and now in Boston

   Rod,
   Sounds good - what about the shrinkage rates ?
   George (down under)


you still need to machine the faces to get them perfectly straight.. so
the shrinkage would not be that of an issue... all whole can be molded
under size and you just machine them to the perfect center and size

regards

Roderick


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.