>> One more question Joe.
         >> Was the EM2 or the Microtec controlling ignition?
         >>
         >> Paul
         >
         >
         > I have the MicroTech. That's what Atkins sells with his engine
         > package. It seems to be a reasonably complete and robust system.
         >
         > Here's a picture of the broken sparkplug.
         >
         > Joe Hull
         > Redmond/Seattle WA, Cozy-Mark-IV - 71hrs
         >
         > Thanks for the picture Joe.
         >
         > I think a slightly smaller gap might prevent the broken ceramic
         > from dropping below the ground electrodes.
         >
         >
         > Paul Lamar ...No rotor no motor.
         >
         > That is a different spark plug from the standard 2nd gen
         > BUR7EQ-L/BUR9EQ-T? Looks more like the spark plug used on
   the first
         > gens?
         > Perry Mick

        Thanks Perry.

        Jim Mederer and Dave Lemon, have you seen this failure before.
        The supposition is the ceramic insulator failure took out the
        apex seal. Is this a common problem in racing engines?
        --
        Paul Lamar ...No rotor no motor.

        Hi Paul,

        A broken plug insulator usually means the plug was too hot,
        detonation - or both.

        Jim Mederer

        Thanks Jim.

        I know it is not a common problem in street engines as there
        have been over a million Mazda rotary engines sold and if this
        were or is a common problem I am sure Mazda would not have sold a
        million engines. This plug was from a normally aspirated engine
        with 35 hours of high power running so detonation was unlikely.

        So keep checking your plugs guys when the engine is new
        to be sure they are not overheating and the plugs are of the right
        heat range.

        It is the duty of the engine builder to put heat range plugs in
        the engine that are consistent with its intended use. If the plugs
        prove to be too cold than adjustments can be made later.

        Jim, given this scenario what plug numbers would you recommend?

        -----------------------------------------------------

        Here is a plug color chart to check your plugs.

        ops that did not work. Try this one.

        --
        Paul Lamar ...No rotor no motor.


   Hi Paul,

        By the way, you cannot read the "color" of rotary plugs and tell
   anything definitive about mixture.  Because of the lack of a cooling
   cycle, the plugs run so hot that, at best mixture (power), the plugs
   come out "white".  You also cannot tune the engine with EGT or O2 - it
   varies all over the map.  Only power matters.

   Jim Mederer

   Bad news :)

   We are now working towards installing a torque meter
   in the gear box so we can know the HP at all times.
   --
   Paul Lamar ...No rotor no motor.


You can derive mixture from fuel flow too..


Matt-

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.