Subject: N93BD is seriously damaged.
From: Rotary Engine
Date: 3/8/2007, 1:03 AM
To: AARotary Engine




    Just to let everyone know I had a serious problem with a landing
    today and the plane is seriously damaged.  Pilot has a scratch on his
    thumb.

    I had a pretty bad bounce on landing and after the second bounce,
    decided to go around. That was a mistake.  I never got out from behind
    the power curve and ended up doing a high power skid into the grass on
    the south side of the runway.  Both main wheels were torn off, the prop
    disintegrated, an the fuselage is somewhat bent.  After contacting the
    ground, the plane did about 1/2 turn and skidded to a stop.

    Bob W.

    --
    N93BD - Rotary Powered BD-4 - http://www.bob-white.com
    First Flight:  11/23/2006 7:50AM - 3.3 Hours Total Time
    Cables for your rotary installation - http://www.roblinphoto.com/shop/

    Dang! I was just about to go over there and take some pictures
    of Bob's airplane. I have never been a fan of tail dragger's.
    I think they add to the hazards of aviation. They are fundamentally
    unstable on the ground. The CG is behind the main wheels. Therefore
    there are situation where they are impossible to control no matter
    how good the pilot.

    ----------------------------------------------------------
    Bob, we are taking an early stand by flight non-stop to Albuquerque
    Monday morning. I'll call you when we arrive. I would like
    to see how the motor mount made out.

    Folks, the news letter will be shut down about noon today for
    a few days. Don't send messages until I get back.

    Paul Lamar ...No rotor no motor.

Glad to hear Bob's okay..


Matt-



Here are a few pictures of Bob's remains. The former owner
engineered and installed a  tail dragger conversion.
The side load riped the main landing gear legs off the fuselage
once it got in the very rough and soft dirt with no damage to the
7075-T6 gear legs themselves.

IMHO the gear leg mounts were not strong enough. On the
other hand the crack the whip force was enough to wrinkle the
fuselage just behind the door. The nose dug in to the soft earth after
the gear legs were gone and the airplane came to a sudden stop which
was enough to buckle the 3/4 inch .049 thick lower motor mount tube
on the left side. There was some evidence of yielding in the aluminum
upper motor mount tube hard points near the firewall. The windshield
was cracked.

The engine was running full power at the time so it cleaned
the Warp Drive carbon fiber blades off the hub. We found some of
the blade parts about 75 feet way from where the plane came to a
complete stop. There was fixable damage to one wing tip and one
horizontal stabilizer tip. The spars appear to be OK.

Bob will convert it back to a nose gear airplane to keep
it on the runway in the first place :)

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.