Subject: PSRU rear seal leak
From: Rotary Engine
Date: 3/8/2007, 8:25 PM
To: AARotary Engine


Hello,

This brings up a question that I have always had with my Ross PSRU.  The
previous owner of my project removed the pilot bearing from the e-shaft.
Was the pilot bearing supposed to be removed?  I would have thought it
should stay to keep the PSRU input shaft centered on the e-shaft.

Cheers,

Burck Hantel

The Ross uses a spring clutch disk bolted solidly to the flex
plate. If that was not done correctly the input shaft
will not be concentric and will not fit the pilot bearing.

Check the run out on the clutch disk.

-- 
Paul Lamar ...No rotor no motor.

Hi Paul,

I picked up a pilot bearing for my e-shaft assuming that the input shaft of
the Ross Drive would fit on it -- it doesn't.  You implied that a pilot bear
is required, is it?  Or should I machine the end of the input shaft so it
would fit the bearing?

Thanks in advance for any advice!

Cheers,

Burck

Yes that should work fine. Machine the shaft to exactly
fit the pilot bearing. With the spring plate disk bolted to
the flex plate you find you cannot insert the shaft into
the pilot bearing the spring clutch disk is not concentric with
the e-shaft. You must then correct that problem.

Also you need to add a needle thrust bearing behind the helical sun
gear. Otherwise the helical sun gear back thrust will wear out
the needle thrust bearing in the front of the rotary engine.
Here is the simple way of doing that. The reason for the
three needle bearings is to reduce the RPM of any one needle
bearing to 1/3 of the input RPM. Needle bearings don't like high RPM.

http://www.timken.com/industries/torrington/products/needle/thrust.asp

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.