Joel Mayhill kindly sent me a couple of old Walbro type
high pressure fuel pumps. Thanks Joel. Naturally I
took one apart to see how they work. This one came
out of a 90 Chev V8 throttle body fuel injection.
They are NOT positive displacement. They are a close kin
to a centrifugal pump. Now I understand why they don't
suck very well. I would not recommend them unless you always
kept them close to the fuel and below the level of the fuel.
They were designed to be mounted in the tank. This one has severe
damage from water. The motor is a simple brush type permanent
magnet DC motor. It will generate a lot of electrical noise
so a capacitor across the contacts is called for.
What I recommend for the constant dribble low cost EFI system
is the MSD positive displacement roller vane pump. It will
be a lot more linear than a centrifugal pump in terms of
fuel delivery being directly proportional to pulse width and
it will suck better in the bargain.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.