Apparently Chuck Dunlap had a bad set of after market apex seal springs.
He experience chatter marks in the rotor housing when he took the engine
apart after an apex seal broke. Now I am not sure that is what caused
the apex seal to break but about the only things that can cause chatter
are weak apex seal springs and the lack of apex seal lubrication.
Also the finish (in micro inches) on the rubbing surface of the apex
seal is an issue. Mazda heats theirs with a laser and chills them
in liquid nitrogen.
The lube was handled by mixing two cycle oil with the fuel.
In the Mazda shop manual they tell you to check the height of the springs
but that is not the full story. Especially if you are buying after
market apex seals and springs. Thickness of the springs vary. You need
to know the material (alloy) the springs are made from and the exact heat
treating process. Quality control on heat treating is a big issue here.
The only way to get somewhat of an idea is to measure the spring rate. You
do this by putting the spring on a scale and measure the forces it takes
to deflect the spring x number of thousands of an inch.
Also you want to keep the rotor (oil) cool as an over heated rotor could
cause the temper on the springs to go away. Apex seals run 500 F normally.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.