Subject: Pick Up tube and dip stick
From: Rotary Engine
Date: 3/10/2007, 3:21 PM
To: AARotary Engine


Paul,  here are a couple of photos of the oil pick up and dip stick
taken before the bottom of the pan was added. The oil pick is .750
o.d. x .49 wall.    I had considered putting a jog in it to move it
closer to the end of the tank but the gain was minimal and not worth
the additional effort.  As is the pick up is .8750 inches  up from
the bottom of the pan.   The tube is TIG Brazed with silicon bronze
rod on the back side of the flange.  You could pick the engine up
with that braze.

Next  is the dip stick. Notice how short it is, extending only 1.125
inches below the pan flange.  You could have six quarts of oil in the
new pan with no reading on the dip stick.   It could be extended two
more inches  and be a lot more useful.

Notice that the dip stick contacted the pan.  Ooops.   I had to add
the tunnel you see in the photos.  Next pan will be .250 wider (each
side) and should clear o.k.    Jerry



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.