Paul--
<snip>
(we ran a junker on only one rotor
with a glass of water on the engine stand and it did not even move),
<snip>
Tom Chapman
<snip>
I meant to comment on this earlier but forgot. How did he do that?
Everything I've ever heard said the rotary runs rough as a cob on one
rotor.
Bob W.
--
N93BD - Rotary Powered BD-4 - http://www.bob-white.com
First Flight: 11/23/2006 7:50AM - 3.8 Hours Total Time
Cables for your rotary installation - http://www.roblinphoto.com/shop/
I was thinking about that myself. Perhaps all the experience we have
had on this is only with Tracy's PSRU and a prop load.
Perhaps what causes the roughness is the one torque
pulse per rev rather than two and the gear box rattles due
to prop inertia load and resonant problems. It might run
smooth with no prop.
Paul Lamar
It would be an interesting test without the prop. Richard Sohn may have
already tried it?
I suspect a major factor is the much reduced moment of inertia of
Tracy's flexplate/driveplate compared to the stock flywheels.
Many a car driver have driven quite a distance on one rotor.
With a one-rotor you will get much larger torque fluctuations and even
reversals without a flywheel.
You also have another huge flywheel moment of inertia in the form of the
prop, decoupled by the planetary set and Tracy's damper plate.
Rubber has an extremely low damping factor, otherwise it would heat up
and melt in short order at resonance. Tracy's pin and rubber bushing "dampers" are
non-linear(IIRC) in response as they
compress (i.e. the become stiffer as they compress), they may be
"bottoming-out" with the one-rotors as they compress fully.
A softer, larger diameter rubber bushing might also help by allowing a
larger travel or stroke.
Another possibility might be the addition of a viscous damper such as
houdaille or the like. Although, these all add weight...
Cheers
Cary
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.