Paul Lamar
It would be an interesting test without the prop. Richard Sohn may have
already tried it?
I suspect a major factor is the much reduced moment of inertia of
Tracy's flexplate/driveplate compared to the stock flywheels.
Many a car driver have driven quite a distance on one rotor.
With a one-rotor you will get much larger torque fluctuations and even
reversals without a flywheel.
You also have another huge flywheel moment of inertia in the form of the
prop, decoupled by the planetary set and Tracy's damper plate.
Rubber has an extremely low damping factor, otherwise it would heat up
and melt in short order at resonance. Tracy's pin and rubber bushing
"dampers" are
non-linear(IIRC) in response as they
compress (i.e. the become stiffer as they compress), they may be
"bottoming-out" with the one-rotors as they compress fully.
A softer, larger diameter rubber bushing might also help by allowing a
larger travel or stroke.
Another possibility might be the addition of a viscous damper such as
houdaille or the like. Although, these all add weight...
Cheers
Cary
Cary,
There was an article in Contact magazine about a chap who was testing
dampers for a 4 cylinder 4 stroke engine for aviation use. This would be
similar to a single rotor torque reversals. He discovered that his rubber
dampers ( like Tracy's) disintegrated in short order. He experimented with
many types of dampers and finally used 6 synthetic, 4wd shackle dampers.
They are in fact harder.
His argument, if I remember it correctly, was that the softer dampers gave
more (obviously), opposite direction to the prop and equally in the torque
reversals , which put the damper in constant and extreme reaction
environment ( my best words to describe the situation).
So it would seem the opposite is true, of what I originally believed. I does
make sense to me!
George ( down under)
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.