Subject: Thermal Bypass Pellet
From: Rotary Engine
Date: 3/10/2007, 2:48 PM
To: AARotary Engine



I'm trying to install a thermal bypass pellet (Tracy's) in my Renesis but
can't seem to get the e-shaft bolt to move with my 1/2" impact wrench.  Can
someone tell me if the bolt is right or left hand thread?

Thanks,
Bob Forbes
Upstate NY
N164WF

Counter clockwise takes it off. Spray a lot of WD40 in there and let
it soak. Do you have the Mazda ring gear locking tool that
keeps the e-shaft from turning? Also a chain wrench will work on
the e-shaft pulley hub. A 3/4 impact wrench should take it off without
locking the e-shaft. 1/2 inch is too small.

Paul Lamar


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.