Subject: Thermal Bypass Pellet
From: Rotary Engine
Date: 3/11/2007, 1:22 PM
To: AARotary Engine


   I'm trying to install a thermal bypass pellet (Tracy's) in my
   Renesis but
   can't seem to get the e-shaft bolt to move with my 1/2" impact
   wrench.  Can
   someone tell me if the bolt is right or left hand thread?

   Thanks,
   Bob Forbes
   Upstate NY
   N164WF

   Counter clockwise takes it off. Spray a lot of WD40 in there and let
   it soak. Do you have the Mazda ring gear locking tool that
   keeps the e-shaft from turning? Also a chain wrench will work on
   the e-shaft pulley hub. A 3/4 impact wrench should take it off without
   locking the e-shaft. 1/2 inch is too small.

   Paul Lamar


lock the fly wheel and of any impact ranch.... if you do not have one
warm the thread to soften the thread lock

regards
Rodercik



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.