Subject: Wright Brothers fuel vaporiser.
From: Rotary Engine
Date: 3/11/2007, 8:02 AM
To: AARotary Engine

I thought of a way of completely vaporising the fuel on our super simple,
super cheap, PWM modulated fuel pump, constant dribble, EFI system.

I stole this idea from the Wright Brothers.

Two 1/2 inch steel rods are bored out on the ends and welded to the
exhaust pipes. They conduct heat up to the intake tubes. The fuel is
fed to the stoves through the two small steel fuel lines shown. No moving
parts. The amount of heat can be controlled by necking down the rods.
Not shown in this 3D. Smaller diameter rod less heat. Something
around 150 to 200 F should do the job. A couple of thermal couples
can monitor the situation during R&D.

No high pressure and no small diameter orifices.

What do you guys think?

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.