I thought of a way of completely vaporising the fuel on our super simple,
super cheap, PWM modulated fuel pump, constant dribble, EFI system.
I stole this idea from the Wright Brothers.
Two 1/2 inch steel rods are bored out on the ends and welded to the
exhaust pipes. They conduct heat up to the intake tubes. The fuel is
fed to the stoves through the two small steel fuel lines shown. No moving
parts. The amount of heat can be controlled by necking down the rods.
Not shown in this 3D. Smaller diameter rod less heat. Something
around 150 to 200 F should do the job. A couple of thermal couples
can monitor the situation during R&D.
No high pressure and no small diameter orifices.
What do you guys think?
-----------------------------------------
Here is the way the Wright Brothers did it. No air throttle.
Basically the throttle was wide open all the time. The fuel
flow was controlled by a simple pet cock valve from a gravity
feed fuel tank and dribbled onto this hot pan surrounding the
intake valves. No mixture control.
The intake valves had a light closing spring and they would open by
vacuum alone on the intake stroke of the engine. No cam shaft.
They would then suck in the fuel vapors along with the air.
Brilliantly simple.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.