I thought of a way of completely vaporising the fuel on our super
simple,
super cheap, PWM modulated fuel pump, constant dribble, EFI system.
I stole this idea from the Wright Brothers.
Two 1/2 inch steel rods are bored out on the ends and welded to the
exhaust pipes. They conduct heat up to the intake tubes. The fuel is
fed to the stoves through the two small steel fuel lines shown. No
moving
parts. The amount of heat can be controlled by necking down the rods.
Not shown in this 3D. Smaller diameter rod less heat. Something
around 150 to 200 F should do the job. A couple of thermal couples
can monitor the situation during R&D.
No high pressure and no small diameter orifices.
What do you guys think?
Paul Lamar ...No rotor no motor.
Might work pretty well.. I wonder what happens during a heat-soak
cycle.. Say you want to restart the engine after being shut down for 5
minutes. And, what will the peak temps be after shutdown. Have to
consider material choices of the other intake components...
Matt-
So you are saying that the exhaust heats the solid steel rods
and conducts the heat into the intake post. Fuel is feed into
a small depression milled into the intake port end of the rod.
The fuel evaporates and is swept into the intake air stream.
Do I have this right?
Some thoughts:
The fuel will cook leaving behind residue. Maybe all the lead
in 100LL will be left behind. This may not be a big deal.
Cleaning the rods at each annual may be sufficient.
Cold starting. The fuel will puddle until enough heat is
generated to evaporate the fuel. Again, probably not a big
deal.
Hot starting. Will the rods be hot enough to ignite the fuel
on contact?
Running. May induce a drop in EGT if all the fuel is burned
in the chamber. May mean cheaper and lighter exhaust systems.
It may effectively lower the octane of the fuel. (Won't a fuel
vapor - air mixture burn faster than a liquid fuel - air
mixture?). Of course with the Wankle's low octane requirement
this need not be of concern unless running with a turbo.
All in all a Great idea, Paul. Now for the implementation.
--Sandy
Correct on the description. The 1/2 inch rod is simply drilled about
1/2 inch deep with a 3/8 drill. Not milled. The 2 inch OD tube bonded
into the rotor housing could be made from stainless steel instead of
aluminum so the rod could be welded to that to form a seal. The other
end of the 1/2" rod could fit in a socket and be clamped to the exhaust
pipe for heat transfer.
Cold starting is not a big deal as you don't care about BSFC.
Hot starting. No, all the rods have to be is around 150 F or higher to
boil the fuel. It takes a spark, very high temperatures or open flame
to ignite the fuel. If it was ignited it would get blown out by
the Mack .4 hurricane of air flowing through the pipe :)
We are still using a pot on the instrument panel to set the amount
of fuel going in for hot starting or cold starting or leaning
the mixture.
Yes it should improve the BSFC. Lycoming heats the intake manifold
to about 200 F by passing it through the hot oil pan. This improves
the mixture distribution and the BSFC at the expense of a bit of
power. We are just heating the fuel without heating the air so
there should be little loss in power.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.