Subject: 2-cycle Oil Mixing RE: Ran the P-port on the test stand
From: Rotary Engine
Date: 3/13/2007, 8:56 PM
To: AARotary Engine


<snips>
Does premix oil settle out of fuel or does it completely disolve?
Because I was curious, I googled this topic, and found some humorous
discussions on it..  Many people believe that the oil settles to the
bottom of the tank and requires somewhat vigorous agitation to bring it
back into solution.  Others say it depends on what type of oil is being
used...  Castor based oils tend to separate more readily.  What kind of
oil does Mazdatrix us

<snips>

Matt-

We used one 50 mm weber.

You know I don't know. Walmart sells two cycle oil by the gallon
and that I think is what most people use.

We had run this engine on the dyno previously. We mainly
wanted to see if we had the internal coolant leak fixed around
the p-port tubes. We have.
-- 
Paul Lamar ...No rotor no motor.

I can't speak to castor oil.  Petroleum 2-cycle oil needs to be 'cut' with
solvents to keep it mixed.  Man-made synthetic (PAO, ester) 2-cycle oil
stays blended without the solvents.  This is one of the reasons why
synthetic 2-cycle oil can be run at lower mix rates and still provide as
good or better protection - the solvents (40%?) don't help lubrication.

For hot environments, like keeping seals free, look for a 2-cycle oil rated
'TC'.  The detergents are tailored to keep the engine clean in the heat.
TC-W3 is designed for cold-running outboard engines.  Rotax requires TC oil
for their water-cooled 2-stroke engines at least partly for the high-temp
cleanliness.

Andy Hecker



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.