The guys at Mazdatrix ran Mark's P-port engine on the
test stand. The cooling system is hooked up to the city
water supply which is about 50 psi. No coolant leaks
anywhere. The engine would start to oil smoke after about
15 minutes of idle. I at first thought it was the oil O-rings
were missing or nicked. Usually when that happens it smokes on
start up. I watched the exhaust ports for any sign of
oil as Kyle slowly turned the engine over. Not a drop.
Strange. We then started the engine and sure enough after
idling for 15 minutes it would start to smoke. Strange.
Then I thought maybe it is loading up with apex seal oil
as it was running very rich. All P-ports miss about 30% of
the time so perhaps the unburned apex seal oil was
accumulating in the bottom of the rotor housings.
Dave told the guys to get a new can of fuel in case
someone had added too much oil. We ran some raw fuel through
the engine to clean the carberator and them let it idle for 15
minutes.
No oil smoke.
So one of two things happened. We had a can of
premix with too much oil in it or that is what p-ports engines
do when you let them idle for 15 minutes. It did not foul the plugs.
as you could stop and start it at will. In fact it started quicker
and easier than my O-470. Actually side port engines up to the RX8
miss at idle too but not as often as P-ports. We took the plugs out
and
there was a little sign of oil but no where near enough to foul
the plugs. This is with a cold engine as we always had a supply
of cold city cooling water.
BTW it would idle down to 1200 RPM despite being too rich.
When you slammed the throttle open there was no stumble or delay.
Paul Lamar ...No rotor no motor.
That is good news. Is the "test stand" the same as the dyno? If
not, was the engine turning a prop?
Jerry
The test stand is a hole in a bench that has a depression in
it. Engine oil is in the depression. An exhaust manifold is
readily available as is a water fitting that bolts on were the water
pump goes. You hook up a few wires and you are ready to run.
The engine just sits there. Nothing is bolted down. It takes only
a few minutes to set up. We ran Perry Mick's engine on the test stand.
Just about every engine Mazdatrix builds they run on this test
stand. Takes way less time than bolting it down on the dyno.
No prop load.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.