Subject: Ran the P-port on the test stand
From: Rotary Engine
Date: 3/13/2007, 3:11 PM
To: AARotary Engine



    The guys at Mazdatrix ran Mark's P-port engine on the
    test stand. The cooling system is hooked up to the city
    water supply which is about 50 psi. No coolant leaks
    anywhere. The engine would start to oil smoke after about
    15 minutes of idle. I at first thought it was the oil O-rings
    were missing or nicked. Usually when that happens it smokes on
    start up. I watched the exhaust ports for any sign of
    oil as Kyle slowly turned the engine over. Not a drop.
    Strange. We then started the engine and sure enough after
    idling for 15 minutes it would start to smoke. Strange.
    Then I thought maybe it is loading up with apex seal oil
    as it was running very rich. All P-ports miss about 30% of
    the time so perhaps the unburned apex seal oil was
    accumulating in the bottom of the rotor housings.
    Dave told the guys to get a new can of fuel in case
    someone had added too much oil. We ran some raw fuel through
    the engine to clean the carberator and them let it idle for 15 minutes.

    No oil smoke.

    So one of two things happened. We had a can of
    premix with too much oil in it or that is what p-ports engines
    do when you let them idle for 15 minutes. It did not foul the plugs.
    as you could stop and start it at will. In fact it started quicker
    and easier than my O-470.  Actually side port engines up to the RX8
    miss at idle too but not as often as P-ports. We took the plugs out and
    there was a little sign of oil but no where near enough to foul
    the plugs. This is with a cold engine as we always had a supply
    of cold city cooling water.

    BTW it would idle down to 1200 RPM despite being too rich.
    When you slammed the throttle open there was no stumble or delay.

    Paul Lamar ...No rotor no motor.



Interesting data..  I wonder why it takes 15 minutes for it to start to
smoke..  Is that how long it takes at idle for it to heat up enough to
actually burn the oil in sufficient quantity to make the smoke visible?
Prior to that it's blowing the same amount of oil, but it isn't visible
as smoke?  If you shut it down and immediately restart it does it smoke
immediately?

Is the level of the oil in the sump changing?

Does premix oil settle out of fuel or does it completely disolve?
Because I was curious, I googled this topic, and found some humorous
discussions on it..  Many people believe that the oil settles to the
bottom of the tank and requires somewhat vigorous agitation to bring it
back into solution.  Others say it depends on what type of oil is being
used...  Castor based oils tend to separate more readily.  What kind of
oil does Mazdatrix us

What kind of fuel delivery system is being used on the dyno?  A couple
of webers?

What's the test plan for this engine?  Just check how much power it puts
out and make sure it doesn't leak?


Matt-

We used one 50 mm weber.

You know I don't know. Walmart sells two cycle oil by the gallon
and that I think is what most people use.

We had run this engine on the dyno previously. We mainly
wanted to see if we had the internal coolant leak fixed around
the p-port tubes. We have.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.