Subject: Ran the P-port on the test stand
From: Rotary Engine
Date: 3/13/2007, 3:22 PM
To: AARotary Engine

     > The guys at Mazdatrix ran Mark's P-port engine on the
     > test stand. The cooling system is hooked up to the city
     > water supply which is about 50 psi. No coolant leaks
     > anywhere. The engine would start to oil smoke after about
     > 15 minutes of idle. I at first thought it was the oil O-rings
     > were missing or nicked. Usually when that happens it smokes on
     > start up. I watched the exhaust ports for any sign of
     > oil as Kyle slowly turned the engine over. Not a drop.
     > Strange. We then started the engine and sure enough after
     > idling for 15 minutes it would start to smoke. Strange.
     > Then I thought maybe it is loading up with apex seal oil
     > as it was running very rich. All P-ports miss about 30% of
     > the time so perhaps the unburned apex seal oil was
     > accumulating in the bottom of the rotor housings.
     > Dave told the guys to get a new can of fuel in case
     > someone had added too much oil. We ran some raw fuel through
     > the engine to clean the carberator and them let it idle for 15
     > minutes.
     > No oil smoke.
     >
     > So one of two things happened. We had a can of
     > premix with too much oil in it or that is what p-ports engines
     > do when you let them idle for 15 minutes. It did not foul the plugs.
     > as you could stop and start it at will. In fact it started quicker
     > and easier than my O-470.  Actually side port engines up to the RX8
     > miss at idle too but not as often as P-ports. We took the plugs
     > out and
     > there was a little sign of oil but no where near enough to foul
     > the plugs. This is with a cold engine as we always had a supply
     > of cold city cooling water.
     >
     > BTW it would idle down to 1200 RPM despite being too rich.
     > When you slammed the throttle open there was no stumble or delay.
     >
     > Paul Lamar ...No rotor no motor.

    Paul is this the engine you had on the Dyno? Do you have any performance
    graphing for it?

    Jarrett

    Yes. Here it is.

    --
    Paul Lamar ...No rotor no motor.



That's just impressive, Paul..  At 6000rpm (loafing) that engine's doing
as much work as an O-470 but weighs probably 100 lb (25%) less..


Matt-

You better believe it! It sure feels and sounds like 240 HP
too :) If you think that is impressive you should have been at
Sun N Fun 2002 when we were running Dave Garbers turbocharged 350 HP
12 A in the work shop area. People for miles around were
impressed :) Look at the size and pitch of that 2 bladed prop
on there. These engines were built in 1973.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.