Subject: Ran the P-port on the test stand
From: Rotary Engine
Date: 3/13/2007, 9:06 PM
To: AARotary Engine



The test stand is a hole in a bench that has a depression in
it. Engine oil is in the depression. An exhaust manifold is
readily available as is a water fitting that bolts on were the water
pump goes.  You hook up a few wires and you are ready to run.
The engine just sits there. Nothing is bolted down.  It takes only
a few minutes to set up. We ran Perry Mick's engine on the test stand.
Just about every engine Mazdatrix builds they run on this test
stand. Takes way less time than bolting it down on the dyno.

No prop load.
-- 
Paul Lamar ...No rotor no motor.

Hi Paul,
ref test stand-
how is the torque reaction absorbed?


What rpm does it run at?

BR, Dave McC

No torque reaction to speak of because there is no load
on the engine. I am not sure what they have run it up to.
I don't think I would want to run it much over 5000 RPM without
bolting it down. Of course the exhaust manifold helps hold it
in place.
-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.