I think you should make all back pans 3 degrees Jerry. Three degrees

down thrust is typical for almost all airplanes.

Paul Lamar

Explain a litter further.  Are you saying you want to tilt ALL pan rear
panels so that the bottom of the pan is closer to the flywheel or the
opposite?   Either way this would require the rear bracket to be milled
at  a compensating angle.   Likewise the side panels would have to be
sheared to match.     $$$$.         Jerry

Yes toward the flywheel. You have to shear the side panels at an angle anyway.
The bracket can be sanded to fit on a disk sander. Its only 3 degrees.
It is up to you. It is not important.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.