I haven't been following this thread very closely, so apologies if
this has already been discussed.  Obviously it has.

 I have 10 beams that I will sell way below cost, $25.00 ea.

Are these for 2 or 3 rotor engines?  I'll take one if it'll fit a 13b.

Bob

Yes,  it will fit a 13B.   I see no reason not to use it on a 20B but
that is a good question to put to the designer. What say you, Paul?

It will be fine. The rear mount takes more of the load.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.