Subject: Thermal Bypass Pellet
From: Rotary Engine
Date: 3/18/2007, 8:43 PM
To: AARotary Engine



you need a to use lock tight... if I am not mistaken it is 220 Nm...
Unfortunately I am still in Boston I still need to go back to Europe to
check the manual.
One important thing.. Never you some sort of a chisel to turn it as you
might bend the e-shaft.

regards
Roderick


On 12/03/07, *Rotary Engine* <rotaryeng@earthlink.net
<mailto:rotaryeng@earthlink.net>> wrote:


    >     I'm trying to install a thermal bypass pellet (Tracy's) in my
    >     Renesis but
    >     can't seem to get the e-shaft bolt to move with my 1/2" impact
    >     wrench.  Can
    >     someone tell me if the bolt is right or left hand thread?
    >
    >     Thanks,
    >     Bob Forbes
    >     Upstate NY
    >     N164WF
    >
    >     Counter clockwise takes it off. Spray a lot of WD40 in there
   and let
    >     it soak. Do you have the Mazda ring gear locking tool that
    >     keeps the e-shaft from turning? Also a chain wrench will work on
    >     the e-shaft pulley hub. A 3/4 impact wrench should take it
   off without
    >     locking the e-shaft. 1/2 inch is too small.
    >
    >     Paul Lamar
    >
    >
    > lock the fly wheel and of any impact ranch.... if you do not have
   one
    > warm the thread to soften the thread lock
    >
    > regards
    > Rodercik

   E-shaft bolt removed.  WOW, 3/4" impact wrench didn't touch it, had
   to use a
   3/4" breaker bar with 3 foot cheater.  Does anyone know what the
   torque lbs
   are for the re-install of the e-shaft bolt?  Should loctite be used when
   doing the re-install?   Looks like there was some kind of
   sealant/loctite
   under the bolt shoulder after I removed it.

   Thanks,
   Bob Forbes
   Upstate NY
   N164WF

   Down load the shop manuals from this site.

   http://www.wankel.net/~krwright/cars/rx7/manuals.html

   Paul Lamar ...No rotor no motor.

You need a to use lock tight... if I am not mistaken it is 220 Nm...
Unfortunately I am still in Boston I still need to go back to Europe to
check the manual.
One important thing.. Never you some sort of a chisel to turn it as you
might bend the e-shaft.

regards
Roderick


The shop manuals are on line.
http://www.wankel.net/~krwright/cars/rx7/manuals.html
You can get them even in Boston.

-- 
Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.