Subject: Warpdrive propeller for bodyflying
From: Rotary Engine
Date: 3/18/2007, 8:53 PM
To: AARotary Engine



Hello guys it makes a long time since my last
communications with you.
But still I follow the conversations.

I am writing today to have your opinion on the
Warpdrive propeller.
I am changing the configuration of my wind tunnels
Instead of using one DC-3 propeller with a 1000 hp
Now I want to use 5, 200 hp motors with 68 inchs
props.

According to my calculations at 2300 rpm and 70 inchs
pitch 3 blades.
I should have 150 mph of wind and 195 hp consumption.
475 pounds in static thrust.

Unless these prop have not the same efficiency than
Hamilton Standard , these calculations should be
accurate enough.

Does any of you knows Warpdrive ?

Thank you very much for your help.

Frank


Hello Frank,

I am obtaining some Warp propellers for a wind tunnel I am now constructing.
When I contacted the manufactures they advised me that each blade can absorb
about 50 hp.  They did not mention the pitch however.

Would you mind sharing your method of calculating.  I was going to have my
blades diameter at 72 inches and thought I would need at least 6 blades to
absorb the 300 hps +

Cheers


Doug Fir

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.