Dear Paul:
The propulsion unit that have in mind will basically require a
13B turbo charged, inter-cooled engine rotating at 7000 rpm. mated 1 to
1 from the flywheel and perhaps a Flexidyne dry fluid coupling enclosed
in a Bell housing or PSRU-like housing coupled to a 2 foot multi-bladed
rotor fan enclosed in a duct.
Given the various detailed descriptions of PSRU units that you
have shown on your site, can you give me any advice regarding the
following:
1. Will there be any possible long term wear and tear to the rotary
engines' main thrust bearings after continued use at those speeds?
Yes.
2. Are there any torsional resonance problems you forsee with a direct
drive short shaft coupled from the engine through the flywheel to the
output bearings of the transmission housing case?
Depends on how stiff the drive shaft and its length.
3. Are there any possible torsional feed back transmitted through the
short drive shaft from the engine to the prop fan and vice-versa?
Its possible.
4. Would a Dodge "Flexidyne" dry fluid coupling attached to the flywheel
and designed to limit the torque and the torsional resonance between the
multi bladed prop fan be a simple solution to the potentional resonance
problems (See Moulton Taylor's solution to torsional vibration issues in
his Imp designed pusher).
Don't really know for sure put it would probable help.
I think it is heavy.
5. In the interest of simplicity would the direct shaft be the only
component within the "Bell housing" and the prop, and would any other
mechanical components be necessary, aside from lubrication and access?
You will need a prop thrust bearing.
6. Can it be made bullet proof?
Yes of course.
7. Would an adaptation of the Flexidyne clutch such as Don Dunbar's 13B
Auto bell housing series 5 in your PSRU section be acceptable to address
the power transmission issues?
Yes.
8. Could a short carbon fiber dry shaft connecting the engine to the
prop fan provide the strength and lightness necessary?
Yes.
9. Could it be assembled from off the shelf parts?
Probably not.
Paul, given your wealth of experience in these matters can you
possibly outline a diagram of such a mechanical arrangement in your reply?
Also, are there any other manufacturers of transmission housings or
members of the newsletter able to give me any advice or information on
the pros and cons of such a lash-up?
Thanking you in advance,
Best regards.
Dave Young
The problem is the ducted prop will be very inefficient
for an aircraft application. It will waste your time and money
and my time. One third of your engine HP will only stir and heat
the air. If you plan on setting any records with a rotary
engine powered aircraft you will need a large diameter prop and
a gear box. No duct. Its been tried and has failed many times before.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.