Subject: Metric pipe fitings
From: Rotary Engine
Date: 3/22/2007, 11:22 AM
To: AARotary Engine



   I'm having problems finding conversion fittings on-line to convert my
   Renesis engine metric pipe threads to NPT.  Does anyone know where I
   can
   find a source for this?  Also, can someone tell me what metric size and
   thread I have for my Renesis main oil feed outlet on the right lower
   side
   (as mounted in the aircraft) that was used to feed the oil cooler?

   Paul, congratulations on your book, can't wait to read it.

   Thx,
   Bob Forbes
   N164WF

   I think McMaster Carr has a few. http://www.mcmaster.com/
   Earl's Supply may have a few. http://www.earlsindy.com/

   And Baker has a few. http://www.bakerprecision.com/

   Metric threads come in several different pitches.
   In the U.S. it is fine and course. There are at least three
   different thread pitches in Metric sizes making it more
   difficult.

   If its female go to a the hardware store and buy several
   different metric thread pitch bolts about the right diameter
   and see which one screws in there easily.

   Also McMaster Carr has Metric thread pitch gages.
   --
   Paul Lamar ...No rotor no motor.

Pegasus Racing has a fair selection of metric fittings too.

Mark S.


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.