I'm having problems finding conversion fittings on-line to convert my
Renesis engine metric pipe threads to NPT. Does anyone know where I can
find a source for this? Also, can someone tell me what metric size and
thread I have for my Renesis main oil feed outlet on the right lower side
(as mounted in the aircraft) that was used to feed the oil cooler?
Paul, congratulations on your book, can't wait to read it.
Thx,
Bob Forbes
N164WF
I think McMaster Carr has a few. http://www.mcmaster.com/
Earl's Supply may have a few. http://www.earlsindy.com/
And Baker has a few. http://www.bakerprecision.com/
Metric threads come in several different pitches.
In the U.S. it is fine and course. There are at least three
different thread pitches in Metric sizes making it more
difficult.
If its female go to a the hardware store and buy several
different metric thread pitch bolts about the right diameter
and see which one screws in there easily.
Also McMaster Carr has Metric thread pitch gages.
--
Paul Lamar ...No rotor no motor.
A metric thread gage is convenient, although not as definitive as the
bolt solution.
Try
www.use-enco.com and search for metric thread gage. They have a variety
from $3.91 to $55.94
Doc Custer
Retired Software Engineer and sometime Audiologist
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.