Paul,

Where do I drill the hole for the 2" tube?  Is it 2" 6061T6 .065 wall?
Where in the intake tract do the injectors go?  Thanks

Joe Berki
Limo EZ

Yes on the 2 " .065 wall. Actually I would try SS as you won't have
to prepare the Al tube for bonding. JB Weld sticks to SS just fine.
Just clean it with acetone.


Just about anywhere you want to put them. Doc is working on
a low cost EFI low pressure constant dribble system so the "injectors"
will be part of the slide throttle. (There are no injectors. Just a hole)
Saves a lot of money. No $1000 EFI computer. No $100 injectors
(four required.).

Also we are thinking of adding a heat stove to vaporize the fuel
so that could be retrofitted to SS but not to Al.


Paul Lamar ...No rotor no motor.

Paul,
If I drill the hole straight without the angle is it 8.55" ?  Is there a
test planned for the injection?  All we need is a magneto and drive the fuel
pump off of the oil metering pump and we are more reliable than a
lycasouraus.

Joe Berki
Limo EZ

I used 8.64 as I recall. Not that critical.

How do you intend modulating the fuel for leaning?

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.