Paul,
I'm trying to get the front cover bolt lose.
But all I produced is a bent aluminum and steel angle.

I tried WD-40 on tehe bolt, but without success.

My brother told me to heat the bolt with a hot-air gun to get the loctite grumpy. Would that work?
What kind of Loctite is used, and up to which temperature is loctite heat resistant?
Kind regards
Thomas


I would not get it over 300 degrees F.
It takes a lot of torque and at least a 3/4 impact Wrench.
You will need to lock down the engine with a special tool
from Mazda or a six foot long channel four inches high by
1/4 inch thick bolted to the flywheel.

Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.