Paul,
Where do I drill the hole for the 2" tube? Is it 2" 6061T6 .065 wall?
Where in the intake tract do the injectors go? Thanks
Joe Berki
Limo EZ
Yes on the 2 " .065 wall. Actually I would try SS as you won't have
to prepare the Al tube for bonding. JB Weld sticks to SS just fine.
Just clean it with acetone.
Just about anywhere you want to put them. Doc is working on
a low cost EFI low pressure constant dribble system so the "injectors"
will be part of the slide throttle. (There are no injectors. Just a hole)
Saves a lot of money. No $1000 EFI computer. No $100 injectors
(four required.).
Also we are thinking of adding a heat stove to vaporize the fuel
so that could be retrofitted to SS but not to Al.
Paul Lamar ...No rotor no motor.
Paul
I was thinking of using stainless before. Since stainless has low thermal
conductivity there may in the difference in expansion factor between
dissimilar metals. If the inner pipe section was press fitted no problem
but
the outer water jacket?
I agree that it would be wise to fill the cavity before boring.
Doug Fir
The temp. diff. on this side of the engine is minimal.
We should test the stove on the ground.
-----------------------------------------------
A good tig welder might be able to weld the SS tube to the steel
rotor housing liners. Worth a try on a junk housing.
Paul Lamar
Fill the cavity with what? JBWeld?
Doc Custer
Retired Software Engineer and sometime Audiologist
Yes. Use acetone thinned JB Weld. It can be done before or after. If it
is done afterwards pressure can be applied while the JB Weld is still
un curred. If this is done one can be assured the JB Weld will fill all
crevices. Also a 45 psi pressure test can be made to insure no coolant leaks.
I think Doug was fooling around in Nepal when we discussed all that :)
If you do it before you are in un charted waters.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.