> Paul,
>
> Where do I drill the hole for the 2" tube? Is it 2" 6061T6 .065 wall?
> Where in the intake tract do the injectors go? Thanks
>
> Joe Berki
> Limo EZ
>
> Yes on the 2 " .065 wall. Actually I would try SS as you won't have
> to prepare the Al tube for bonding. JB Weld sticks to SS just fine.
> Just clean it with acetone.
>
>
> Just about anywhere you want to put them. Doc is working on
> a low cost EFI low pressure constant dribble system so the "injectors"
> will be part of the slide throttle. (There are no injectors. Just a
hole)
> Saves a lot of money. No $1000 EFI computer. No $100 injectors
> (four required.).
>
> Also we are thinking of adding a heat stove to vaporize the fuel
> so that could be retrofitted to SS but not to Al.
>
> Paul Lamar ...No rotor no motor.
Paul
I was thinking of using stainless before. Since stainless has low thermal
conductivity there may in the difference in expansion factor between
dissimilar metals. If the inner pipe section was press fitted no problem
but
the outer water jacket?
I agree that it would be wise to fill the cavity before boring.
Doug Fir
The temp. diff. on this side of the engine is minimal.
We should test the stove on the ground.
-----------------------------------------------
A good tig welder might be able to weld the SS tube to the steel
rotor housing liners. Worth a try on a junk housing.
Paul Lamar
Why don't we just use aluminum. In composite aircraft construction we embed
al parts all of the time. Just etch and alodine. No big deal.
Joe
Aluminum might soften around the heat stove and leak fuel on
to the hot exhaust. If you are using a heat stove that is.
--
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.