Subject: Cutting P Port
From: Rotary Engine
Date: 3/25/2007, 8:25 AM
To: AARotary Engine



I was looking at new rotor housings, and the prices vary about
$100-150 each depending on year model. For PP use
does it matter which one is used? Where is the best place to buy them?
Buly

Year does not matter Buly. The later turbo versions might be slightly
better.

Paul Lamar ...No rotor no motor.

hi all,    do not buy any old stock.  the housings are much improved and
closer tolerance since the new man. facility was put on line in 03. the
liner is cast more accurately and i suspect a little thicker so it can be
ground before the plating process, unlike the old housings.  this results in
an even coat of .005 of chrome. the last ones i purchased were series 5
turbo was the lower price. about $400  i bought from Adam at RX7 specialties
in calgary alberta canada.  they will also groove the hot side water jacket
very reasonable, if you are building a turboed engine. wyo. walt.

The liner is not cast Walt. It is formed out of mild sheet steel.
The pics were taken by me and Robin in 2004.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.