> I was looking at new rotor housings, and the prices vary about
> $100-150 each depending on year model. For PP use
> does it matter which one is used? Where is the best place to buy them?
> Buly
>
> Year does not matter Buly. The later turbo versions might be slightly
> better.
>
> Paul Lamar ...No rotor no motor.
hi all, do not buy any old stock. the housings are much improved and
closer tolerance since the new man. facility was put on line in 03. the
liner is cast more accurately and i suspect a little thicker so it can be
ground before the plating process, unlike the old housings. this results
in
an even coat of .005 of chrome. the last ones i purchased were series 5
turbo was the lower price. about $400 i bought from Adam at RX7
specialties
in calgary alberta canada. they will also groove the hot side water
jacket
very reasonable, if you are building a turboed engine. wyo. walt.
The liner is not cast Walt. It is formed out of mild sheet steel.
The pics were taken by me and Robin in 2004.
Paul Lamar
So where should we buy "new" or good rotor housings?
Joe Berki
Shop around. Mazdatrix sells new parts.
Also builder Bob Mears on here is a Mazda dealer.
"Here's a link to my web page
http://mears-spitfire.tripod.com/ Lots of pics there.
I can get RX8 gaskets for anybody for $49.95 + shipping Any Mazda parts needed for this group will be discounted through my parts department. Call Ronnie Kenley, my parts manager, let him know your
part of the rotary aircraft group. 800 692 4497"
Let us know what you come up with.
Paul Lamar ...No rotor no motor.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.