Subject: DC Power for low pressure dribble system
From: Rotary Engine
Date: 3/25/2007, 11:08 PM
To: AARotary Engine


A hand held and built in radio, Dynon glass flight instruments and GPS. I'm
going to use steam gages for the water and oil pressures and temperatures.
They don't use many amps but I was wondering about the fuel pump(s).
I'm also trying to figure out how to coordinate the fuel flow with the
throttle since my slide throttle is not like the one for the "P" port. May
have to leave the fuel off untill the engine is cranking, like the Posey
carburetor. Karibian




Do you think 30 amps is enough juice run the low pressure dribble system
plus electronics?  Karibian


Yes I think so. I tested one of those junk fuel pumps that Joel sent me from
a 95 Ford Explorer and it was only about 2 amps.
The PICAXE would probably be less than .1 amp.

Depends on what you mean by electronics. Radios?
--
Paul Lamar ...No rotor no motor.


A hand held and built in radio, Dynon glass flight instruments and GPS. I'm
going to use steam gages for the water and oil pressures and temperatures.
They don't use many amps but I was wondering about the fuel pump(s).
I'm also trying to figure out how to coordinate the fuel flow with the
throttle since my slide throttle is not like the one for the "P" port. May
have to leave the fuel off untill the engine is cranking, like the Posey
carburetor. Karibian



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.