Subject: tig welding to chrome
From: Rotary Engine
Date: 3/25/2007, 8:52 AM
To: AARotary Engine


Has anybody tried, or can you try, tig welding SS to a chrome bumper?
-- 
Paul Lamar ...No rotor no motor.


Should be no problem,
The chrome,nickel, and copper will burn off, or will
amalgamate, leaving the steel.
A few considerations:
Some earlier bumpers were tempered, so the localized area will lose temper.
Although the SS will flow nicely, and look pretty, It will not give nax
strength if that is what is required.

Archie

I was thinking of welding a SS tube into a hole
in the chrome plated mild steel rotor housing liner.

Thanks for you comments. I think I will get a junk
rotor housing and try this. We can chamfer the hole
in the rotor housing liner so perhaps that will expose
a enough mild steel to work.
Paul Lamar

An SS welding rod should be used or it might rust in the vicinity. Any
exposed MS tends to rust.
Rolf Pfeiffer


So do the cast iron end housing Rolf. If the engine is run every now
and then it should be coated with apex seal oil. After it is welded
it will be hand chamfered  with a die grinder. That is what
Mazdatrix does when they build the engine. That will leave just a
1/16th wide narrow band of mild steel and SS alloy.

I think it is worth a try. This joint is the critical joint
in the converted p-port process as it keeps coolant out of the
combustion chamber. There is no load on it to speak of and the
SS tube will still be bonded in with JB Weld as a belt and suspenders
approach.


Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.