Subject: Cutting P Port
From: Rotary Engine
Date: 3/26/2007, 12:27 PM
To: AARotary Engine


Paul,
Where do I drill the hole for the 2" tube? Is it 2" 6061T6 .065 wall? Where in the intake tract do the injectors go? Thanks
Joe Berki Limo EZ
Yes on the 2 " .065 wall. Actually I would try SS as you won't have to prepare the Al tube for bonding. JB Weld sticks to SS just fine. Just clean it with acetone.

Just about anywhere you want to put them. Doc is working on a low cost EFI low pressure constant dribble system so the "injectors" will be part of the slide throttle. (There are no injectors. Just a
hole)
Saves a lot of money. No $1000 EFI computer. No $100 injectors (four required.).
Also we are thinking of adding a heat stove to vaporize the fuel so that could be retrofitted to SS but not to Al.


Paul Lamar ...No rotor no motor.

Paul

I was thinking of using stainless before. Since stainless has low
thermal
conductivity there may in the difference in expansion factor between dissimilar metals. If the inner pipe section was press fitted no
problem > but
the outer water jacket?

I agree that it would be wise to fill the cavity before boring.
Doug Fir
The temp. diff. on this side of the engine is minimal. We should test the stove on the ground.
-----------------------------------------------
A good tig welder might be able to weld the SS tube to the steel rotor housing liners. Worth a try on a junk housing.
Paul Lamar

I don't know what alloy the AL rotor housing are made of, or if they have been heat treated, so I may be raising a non-issue.
My "Performance Welding Handbook, 2nd ed." by Richard Finch notes that welding 6061 T6 aluminum will reduce its strength from 45,000 psi to 18,000 to 35,000 psi if not re-heat treated, p 109. He describes two methods of heat treating 6061, Solution Heat Treat resulting in a T4 condition, and Precipitation Heat Treat resulting in a T6 condition, p.110.
I doubt that Mazda used 6061 to cast the rotor housings, because I believe there are better alloys for casting purposes. But they might have. NASA used 6061-T6 to fabricate the crew compartment in the space shuttles.
Nevertheless, caution should be exercised when welding heat treated aluminum. Unless re-heat treated again, the strength of the welded area might be severely reduced.
The author recommends using a Brinell tester in the area of the weld. "Brinell hardness testers are light and portable, and every welding fabrication shop ... should have one."
I am ordering mine today. If I can find one as described in the book. Maybe a welding supply store... Doc Custer Retired Software Engineer and sometime Audiologist
I am not avocating welding to the aluminum Doc. Just to the chrome plated mild steel liner you can see in these pictures. -- Paul Lamar ...No rotor no motor.
Paul,
Another possibility is to friction weld the tube to the steel. A carefull fitting of the tube would be required. In your area Paul there are probably aerospace welding firms that could do it for you.  These are very reliable welds. They use them to weld the shaft to the rotor head on many military helicopters.
Bill Jepson

I don't think that will work as the tube end is not square
nore is the rottor housing surface.
Friction welding works by spinning the parts up and jaming
them togehter.


Paul Lamar ...No rotor no motor.

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2006 All world wide rights reserved.